Materials this product is used on

• Concrete
• Polyurethane foam
• Cement sheeting
• Plywood
• Metal
• Particleboard
• Plasterboard
• Cement render
• Timber
• Expanded polystyrene

How to use product

• All surfaces mustbe clean and free of dirt, oil and pooled water.
• Sand painted surfaces.
• Use Fuller Maxbond Fast Grip between these temperatures, -5ºC to 90ºC.
• Cut tip off Fuller Maxbond Fast grip cartridge, fit nozzle,load into a caqrtridge gun, and cut nozzle to a desired size.
• Dispense a bead of adhesive onto one surface.
• Within 20 minutes, fit surfaces together and press firmly.
• If bond is under immediate stress, support or clamp until a strong bond develops.
• In heavy load applications eg subfloors, use nails or screws in addition to Maxbond Fast Grip.
• For overlay flooring, follow manufacturer's instructions.
• To clean up wet Maxbond Fast Grip use water. If dried use a scraper or sandpaper.
• Fuller Maxbond Fast Grip takes 20 mins to skin and full cure 24 hrs depending on conditions.
• With this product you have 60 minutes of repositioning time.
• You can store this product up to 24 mths unopened.

Not recommended for

• Protect from contact with water.
• High humidity or poor ventilation will result in slow drying.
• Not suitable where both surfaces are non porous.
• In applications where a load will be carried by the bond, the use of mechanical fasteners is
  recommended to prevent creep or substrate failure.
• Not suitable for bonding plank or engineered flooring to concrete slabs (old or new) due to the
  potential of cupping of the timber floor. HB Fuller recommends using Fullers Floorbond MS or XMS
  for these applications.
• Check with flooring manufacturer to ensure complete instructions are obtained.
• Ensure flooring is laid in accordance with Australian standard guidelines
• Not suitable for apllications requiring elastic properties